Update Schedule - H3C MSR Series Command Reference Manual

Parameters
ip ipv4-address: Specifies a source IPv4 address or IPv4 subnet, in dotted decimal notation.
mask-length: Specifies the mask length for IPv4 addresses, in the range of 0 to 32.
ipv6 ipv6-address: Specifies a source IPv6 address or IPv6 subnet.
prefix-length: Specifies the prefix length for IPv6 addresses, in the range of 0 to 128.
Usage guidelines
The following matrix shows the command and hardware compatibility:
Hardware
MSR810/810-W/810-W-DB/810-LM/810-W-LM/810-10-PoE/810-LM
-HK/810-W-LM-HK
MSR810-LMS/810-LUS
MSR2600-10-X1
MSR 2630
MSR3600-28/3600-51
MSR3600-28-SI/3600-51-SI
MSR3610-X1/3610-X1-DP/3610-X1-DC/3610-X1-DP-DC
MSR 3610/3620/3620-DP/3640/3660
MSR5620/5660/5680
If you execute this command multiple times for the same NBAR rule, the most recent configuration
takes effect.
The ipv6 ipv6-address option is not supported in the current software version. If you specify this
option, the command does not take effect.
Examples
# Configure user-defined NBAR rule abcd to match packets sourced from the IPv4 subnet
192.168.2.0/24.
<Sysname> system-view
[Sysname] nbar application abcd protocol http
[Sysname-nbar-application-abcd] source ip 192.168.2.0 24
Related commands
nbar application

update schedule

Use update schedule to set the update schedule for automatic update, including the update interval
and update time.
Use undo update schedule to restore the default.
Syntax
update schedule { daily | weekly { fri | mon | sat | sun | thu | tue | wed } } start-time time tingle
minutes
undo update schedule
862
Command compatibility
Yes
No
Yes
Yes
Yes
No
Yes
Yes
Yes