Exclude-Attribute (Mac Binding Server View) - H3C MSR Series Command Reference Manual

Field
Type
Action
Status
Source
IP
Mask
Prefix length
VLAN
Protocol
Destination
Port

exclude-attribute (MAC binding server view)

Use exclude-attribute to exclude an attribute from portal protocol packets.
Use undo exclude-attribute to not exclude an attribute from portal protocol packets.
Syntax
exclude-attribute attribute-number
undo exclude-attribute attribute-number
Default
No attributes are excluded from portal protocol packets.
Views
MAC binding server view
Predefined user roles
network-admin
Parameters
attribute-number: Specifies an attribute by its number in the range of 1 to 255.
Usage guidelines
Support of the portal authentication server for portal protocol attributes varies by the server type.
During MAC-trigger authentication, the device and the server cannot communicate if the device
sends the portal authentication server a packet that contains an attribute unsupported by the server.
Description
Type of the Web redirect rule:
•
Static—Static Web redirect rule, generated when the Web redirect
feature takes effect.
•
Dynamic—Dynamic Web redirect rule, generated when a user visits a
redirect webpage.
Action in the Web redirect rule:
•
Permit—Allows packets to pass.
•
Redirect—Redirects the packets.
Status of the Web redirect rule:
•
Active—The Web redirect rule is effective.
•
Inactive—The Web redirect rule is not effective.
Source information in the Web redirect rule.
Source IP address.
Subnet mask of the source IPv4 address.
Prefix length of the source IPv6 address.
Source VLAN. If not specified, this field displays Any.
Transport layer protocol in the Web redirect rule:
•
Any—No transport layer protocol is limited.
•
TCP—Transmission Control Protocol.
Destination information in the Web redirect rule.
Destination transport layer port number. The default port number is 80.
299