Ip Configuration - Proxim ORiNOCO AP-8000 User Manual

Access Point Features
Configuring the Device
accepting new stations or new traffic, or to adapt to changes in the offered load. The EDCA parameters assign priorities
to traffic types where higher priority packets gain access to the wireless medium more frequently than lower priority
packets.
NOTE: Default recommended values for EDCA parameters have been defined; Proxim recommends not to modify
EDCA parameters unless strictly necessary.
QoS EDCA Features
• Profile Name: This parameter is used to displays the name for the Wireless QoS EDCA profile.
• STA CW Min: This parameter is used to configure the minimum value for CW for the wireless QoS EDCA profile.
• STA CW Max: This parameter is used to configure the maximum value for CW for the wireless QoS EDCA profile.
• STA AI FSN: This parameter is used for configure the AIFSN value for the wireless QoS EDCA profile.
• STA TXOP: The parameter is used to configure TXOP value for wireless QoS EDCA profile.
• STA ACM: This parameter is used to configure the status for ACM.
• AP CW Min: This parameter is used to configure the minimum value for CW for the AP.
• AP CW Max: This parameter is used to configure the maximum value for CW for the AP.
• AP TXOP: This parameter is used to configure the TXOP value for the AP.
• AP ACM: This parameter is used to configure the status of the APACM for the QoS EDCA profile.
802.1D to IP DSCP Mapping Table Features
• 801.1D to IPDSCP index: This parameter indicates IP DSCP index corresponding to 802.1D priority.
• Lower Limit: This parameter is used to specify IP DSCP lower limit.
• Upper Limit: This parameter is used to specify IP DSCP upper limit.
802.1D to 802.1p Mapping Table Features
• 801.1D Priority: This parameter is used to specify the 802.1d priority and is used as the secondary index to the
802.1D to 802.1p mapping table.
• 802.1p Priority: The parameter is used to specify the 802.1D to be mapped to a 802.1p priority.
QoS Profile Features
• QoS Profile Name: This parameter displays the name of the QoS profile name that been assigned.
• Policy Name: This parameter displays the QoS Policy profile name.
• EDCA Profile Name: This parameter displays the name of the QoS EDCA profile name.
• QoS NACK Status: This parameter is used to configure the status of the QoS profile ACK status.
QoS Policy Features
• Policy Name: This parameter displays the policy name.
• Policy Type: This parameter is used to configure the QoS type. Policy type can be configured for the following;
Inbound Layer2, Inbound Layer3, Outbound Layer2, and Outbound Layer3.
• Priority Mapping: This parameter is used for configuring the primary index to the QoS 802.1D to 802.1p mapping
table.
• Marking Status: This parameter is used to enable or disable the QoS marking.

IP Configuration

The network (internet (TCP/IP)) settings for the Access Point can be either entered manually (static IP address, subnet
mask, and gateway IP address) or obtained automatically (dynamic).
AP-8000 User Guide
43