Mib Browser For Snmp Interface; Using Mib Browser In Snmpv1-V2C; Using Mib Browser In Snmpv3 - Proxim Tsunami MP-8100 Series Reference Manual

MIB Browser for SNMP Interface

To select the preferred SNMP protocol version, go to Configuration Tab on the NuDesign MIB Browser Pro 8.2 and mark the
version either as v1, v2c or v3.

2.1 Using MIB Browser in Snmpv1-V2c

To access the SNMPv1-v2c agent through MIB browser
1. Add the device IP address in the Dest IP Address field.
2. Enter the read community string and write community strings. The same should be configured in the device also. If
the user doesn't configure anything, the default community/password public is used.
NOTE: The above configuration procedures are created by considering the NuDesign's MIB Browser Pro 8.2.

2.2 Using MIB Browser in SNMPv3

To access the SNMPv3 agent through MIB browser
1. In the MIB browser, click Tools > Options. The MIBrowser's current USM User table is displayed, as shown below.
Tsunami MP-8100 Reference Manual
Figure 2-1 NuDesign MIB Browser
2
69