Protection - Renesas M16C FAMILY series Hardware Manual

M 1 6 C 2 / 8 G o r u p ( M 1 6 C

20.3 Protection

Set the PRC2 bit to "1" (write enabled) and then write to any address, and the PRC2 bit will be cleared to "0"
(write protected). The registers protected by the PRC2 bit should be changed in the next instruction after
setting the PRC2 bit to "1". Make sure no interrupts or DMA transfers will occur between the instruction in
which the PRC2 bit is set to "1" and the next instruction.
R e . v 2 0 . 0 J a . n 3 , 1 2 0 0 7
R E J 0 9 B 0 0 4 7 0 - 2 0 0
2 / , 8 M 1 6 C 2 / 8 ) B
page 355
f o 3 8 5
20. Precautions