Precautions - Renesas M16C FAMILY series Hardware Manual

M 1 6 C 2 / 8 G o r u p ( M 1 6 C

16.14 Precautions

(1) Access to the registers of I
The following is precautions when read or write the control registers of I
•S00 register
Do not rewrite the S00 register during data transfer. If the bits in the S00 register are rewritten, the bit
counter for transfer is reset and data may not be transferred successfully.
•S1D0 register
The BC2 o BC0 bits are set to "0002" when START condition is detected or when 1-byte data transfer
is completed. Do not read or write the S1D0 register at this timing. Otherwise, data may be read or
written unsuccessfully. Figure 16.22 and Figure 16.23 show the bit counter reset timing.
•S20 register
Do not rewrite the S20 register except the ACKBIT bit during transfer. If the bits in the S20 register
except ACKBIT bit are rewritten, the I
pletely.
•S3D0 register
Rewrite the ICK4 to ICK0 bits in the S3D0 register when the ES0 bit in the S1D0 register is set to "0"
2
(I C bus interface is disabled). When the WIT bit is read, the internal WAIT flag is read. Therefore, do
not use the bit managing instruction(read-modify-write instruction) to access the S3D0 register.
•S10 register
Do not use the bit managing instruction (read-modify-write instruction) because all bits in the S10
register will be changed, depending on the communication conditions. Do not read/write when te com-
munication mode select bits, the MST and TRX bits, are changing their value. Otherwise, data may be
read or written unsuccessfully. Figure16.21 to Figure 16.23 show the timing when the MST and TRX
bits change.
R e . v 2 0 . 0 J a . n 3 , 1 2 0 0 7
R E J 0 9 B 0 0 4 7 0 - 2 0 0
2 / , 8 M 1 6 C 2 / 8 ) B
2
C bus interface circuit
2
C bus clock circuit is reset and data may be transferred incom-
page 279
f o 3 8 5
2
16. MULTI-MASTER I C bus INTERFACE
2
C bus interface circuit