Modify Banner And Prompt Commands - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Fast Ethernet Managed Switch CLI Reference Guide
M B
ODIFY ANNER AND
Administrator level users can modify the login banner (greeting message) and command prompt by using the
commands described below.
Command
config command_prompt
config greeting_message
show greeting_message
The Modify Banner and Prompt commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
config command prompt
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To modify the command prompt to "AtYourService":
DES-3528:admin#config command_prompt AtYourService
Command: config command_prompt AtYourService
Success.
AtYourService:admin#
config greeting _message
Purpose
Syntax
Description
Parameters
P
ROMPT
Parameters
[<string 16> | username | default]
{default}
Used to configure the command prompt.
config command_prompt [<string 16> | username | default]
This command is used to change the command prompt.
string 16 –The command prompt can be changed by entering a new name of no more that 16
characters.
username – The command prompt will be changed to the login username.
default – The command prompt will reset to factory default command prompt.
Only Administrator and Operator-level users can issue this command. Other restrictions
include:
•
If the "reset" command is executed, the modified command prompt will remain
modified. However, the "reset config/reset system" command will reset the
command prompt to the original factory banner.
Used to configure the login banner (greeting message).
config greeting _message {default}
This command is used to modify the login banner (greeting message).
default – If the user enters default to the modify banner command, then the banner will be
reset to the original factory banner.
To open the Banner Editor, click enter after typing the config greeting_message command.
Type the information to be displayed on the banner by using the commands described on the
Banner Editor:
Quit without save:
Save and quit:
Move cursor:
Delete line:
C
OMMANDS
Ctrl+C
Ctrl+W
Left/Right/Up/Down
Ctrl+D
24