Connecting To Power; Connecting To Lan - R&S SMM100A Getting Started

®
R&S SMM100A
3.6

Connecting to Power

For safety information, see
1. Plug the AC power cable into the AC power connector on the rear panel of the
instrument. Only use the AC power cable delivered with the R&S SMM100A.
2. Plug the AC power cable into a power outlet with ground contact.
The required ratings are listed next to the AC power connector and in the data
sheet.
3.7

Connecting to LAN

Network environment
Before connecting the product to a local area network (LAN), consider the follow-
ing:
● Install the latest firmware to reduce security risks.
● For internet or remote access, use secured connections if applicable.
● Ensure that the network settings comply with the security policies of your com-
pany. Contact your local system administrator or IT department before con-
necting your product to your company LAN.
● When connected to the LAN, the product may potentially be accessed from
the internet, which may be a security risk. For example, attackers might mis-
use or damage the product.
To connect to LAN
The connector is located on the
► Connect the LAN socket via an RJ-45 cable to the LAN.
By default, the R&S SMM100A is configured to use DHCP (dynamic host configu-
ration protocol) and no static IP address is configured.
If switched on and connected to the LAN, the R&S SMM100A displays the
address information on the screen.
Getting Started 1179.1335.02 ─ 02
"Connecting to power"
rear panel .
Preparing for Use
Connecting to LAN
on page 9.
18