Table of Contents
Advertisement
®
R&S
SMM100A
Display Port, DVI
Provided for future use.
LAN
RJ-45 connector to connect the R&S SMM100A to a LAN for remote control,
remote operation, and data transfer.
How to:
Chapter 3.7, "Connecting to
USB/USB In
● Two female USB type A connectors, to connect devices like a keyboard, a
mouse, a memory stick, or the R&S NRP-Z3/Z4 cable for the R&S NRP power
sensors
● Female USB In connector (USB type B), for example for remote control.
How to:
Chapter 3.8, "Connecting USB
AC power supply connector and switch
Mains power switch for performing the following tasks:
● Connecting the internal power supply to the power source
● Disconnecting the internal power supply from the power source
How to:
Chapter 3.6, "Connecting to
User x
BNC multipurpose connectors for defining input signals and output signals.
Table 4-8
lists the signals assigned to the User x connectors in the default instru-
ment state.
Table 4-8: Default configuration of the User x connectors
User connector
4
5
6
A dedicated LED indicates the connector status:
●
green: an input connector
●
yellow: an output connector
●
no light / gray: the connector is not active
See also chapter "Global Connector Settings" in the user manual.
Getting Started 1179.1335.02 ─ 02
LAN",
on page 18
Devices",
Power",
on page 18.
Direction
Input
Output
Not used
Instrument Tour
Rear Panel Tour
on page 19
Default assigned signal
Global Trigger 2
Signal Valid
None
37
Advertisement
Table of Contents
