First Steps With The Instrument; Configuring A Cw Signal With The R&S Sgma-Gui - R&S SGS100A Getting Started

®
R&S SGS100A
4

First Steps with the Instrument

This section provides examples on how to configure the R&S SGS to generate a
continuous wave (CW) signal via the R&S SGMA-GUI and the R&S SGS100A
Web-GUI.
4.1 Configuring a CW Signal with the R&S SGMA-
GUI
The R&S SGS in this example is a base unit equipped with the frequency option
R&S SGS-B106.
As a prerequisite for this example, the R&S SGS has to be connected to a remote
PC. The R&S SGMA-GUI software has to be installed on this remote PC and the
instrument is added to the list of "Available Instruments".
Figure 4-1: Example of the setup
For information on how to fulfill these requirements, refer to
●
Chapter 2.3.2.1, "Connecting the Instrument to the
on page 19
●
Chapter 2.3.1, "Installing the R&S SGMA-GUI
●
Chapter 2.3.2.3, "Automatically Adding Instruments to the SGMA-GUI
on page 22
1. Check the front panel of the R&S SGS.
Getting Started 1416.0570.02 ─ 11
Configuring a CW Signal with the R&S SGMA-GUI
First Steps with the Instrument
Network",
Software", on page 17
",
32