Network; Bootfile; Domain-Name - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual

Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-

7.1.9 network

Use this command to configure the subnet number and mask for a DHCP address pool on
the server. Network-number is a valid IP address, made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified
address pool. The prefix-length is an integer from 0 to 32.
Default
Format
Mode
7.1.9.1 no network
This command removes the subnet number and mask.
Format
Mode

7.1.10 bootfile

The command specifies the name of the default boot image for a DHCP client. The
specifies the boot image file.
<filename>
Default
Format
Mode
7.1.10.1 no bootfile
This command deletes the boot image name.
Format
Mode

7.1.11 domain-name

This command specifies the domain name for a DHCP client. The
domain name string of the client.
Default
Format
Mode
7-6
none
network <networknumber> [mask | prefixlength]
DHCP Pool Config
no network
DHCP Pool Config
none
bootfile <filename>
DHCP Pool Config
no bootfile
DHCP Pool Config
none
domain-name <domain>
DHCP Pool Config
v1.0, December 2005
specifies the
<domain>
DHCP Commands