Ip Domain-Lookup; Ip Domain-Name; Ip Name-Server - NETGEAR FSM7328PS - ProSafe 24 Port 10/100 L3 Managed Stackable Switch Reference Manual

Command Line Interface Reference for the ProSafe 7300S Series Layer-3 Stackable Switches,

4.5.1 ip domain-lookup

To enable the IP Domain Naming System (DNS)-based host name-to-address translation,
use the ip domain-lookup global configuration command. To disable the DNS, use the no
form of this command
Format
Mode
Default

4.5.2 ip domain-name

To define a default domain name (<name>) that the software uses to complete unqualified
host names (names without a dotted-decimal domain name), use the ip domain-name
global configuration command. To remove default domain name, use the no form of this
command.
Default domain used to complete unqualified host names. Do not include the initial period
that separates an unqualified name from the domain name.
<name> is a string of 1 to 255 characters.
Format
Mode

4.5.3 ip name-server

To set the available name servers, use the ip name-server global configuration command.
<server-address> is IP addresses of the name server. Up to 8 servers can be defined in one
command, or by using multiple commands. The preference of the servers is determined by
the order they were entered. To remove a name server, use the no form of this command.
Format
Mode
Port and System Setup Commands
[no] ip domain-lookup
Global Config
enabled
name
ip domain-name
no ip domain-name
Global Config
[no] ip name-server
server-address8]
Global Config
v3.0, January 2008
server-address1 [server-address2 ...
4-25