Switchport Protected (Interface Config); Show Switchport Protected - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

switchport protected (Interface Config)

Use this command to add an interface to a protected port group. The <groupid> parameter
identifies the set of protected ports to which this interface is assigned. You can only configure an
interface as protected in one group.
Note: Port protection occurs within a single switch. Protected port configuration does not
affect traffic between ports on two different switches. No traffic forwarding is
possible between two protected ports.
Default unprotected
Format
switchport protected <groupid>
Mode Interface Config
no switchport protected (Interface Config)
Use this command to configure a port as unprotected. The groupid parameter identifies the set
of protected ports to which this interface is assigned.
Format
no switchport protected <groupid>
Mode Interface Config

show switchport protected

This command displays the status of all the interfaces, including protected and unprotected
interfaces.
Format
show switchport protected <groupid>
Mode • Privileged EXEC
• User EXEC
Term Definition
Group ID The number that identifies the protected port group.
Switching Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
3-53