Web Interface: Configure A Protected Port To Isolate Ports; On The Switch - NETGEAR M4200 Software Administration Manual

Web Interface: Configure a Protected Port to Isolate Ports

on the Switch

1. Create a DHCP pool:
Note: This example assumes that the DHCP service is enabled. For
information about how to enable the DHCP service, see the web
interface procedure in
page 466.
a. Select System > Services > DHCP Server > DHCP Server Configuration.
A screen similar to the following displays.
b. Under DHCP Pool Configuration, enter the following information:
• In the Pool Name field, select Create.
• In the Pool Name field, enter pool-a.
• In the Type of Binding field, select Dynamic.
• In the Network Number field, enter 192.168.1.0.
• In the Network Mask field, enter 255.255.255.0.
• In the Days field, enter 1.
• Click Default Router Addresses. The DNS server address fields display. In the
first Router Address field, enter 192.168.1.254.
• Click DNS Server Addresses. The router address fields display. In the first DNS
Server Address field, enter 12.7.210.170.
c. Click Add.
Managed Switches
Configure a DHCP Server in Dynamic Mode
Security Management
312
on