Set Port Self-Loop-Discovery Admin-Status Command; Set Port Channel Command - Avaya P333T User Manual

Chapter 6 Cajun Campus CLI – Layer 2

Set port self-loop-discovery Admin-Status Command

Use the set port self-loop-discovery Admin_Status command to
enable or disable a port's IBM token ring discovery mode on a module level.
The syntax for this command is:
set port self-loop-discovery Admin_Status <enable|disable>
<module/port>
Example:
Cajun_P330-N# set port self-loop-discovery Admin-Status enable
1/2
Self-Loop-Discovery enabled on port 1/2.

Set port channel Command

Use the set port channel command to enable or disable a Link Aggregation
Group (LAG) interface on the module. You can also add or remove a port from an
existing LAG. Ensure that all ports in the LAG are configured with the same ports'
parameters such as port speed, duplex mode, VLAN ID, tagging mode, priority
level. When adding a port to an existing LAG, type the same LAG-name (or no
LAG-name), otherwise you will get an error message. The added port must belong
to the same connector octet - refer to the "LAG" indication on device's front panel.
The syntax for this command is:
set port channel <mod_num>/<port_list> {on|off} [<LAG-name>]
port_list
LAG-name
Example:
Cajun_P330-N# set port channel 1/6,18 on server2
Port 1/6 channel mode set to on
Port 1/18 was added to channel
90
A list of ports to be aggregated, separated by commas
Optional name for the LAG interface
Avaya P333T User's Guide