Set Leaky-Vlan - Avaya P333R User Manual

set leaky-vlan

Use the set leaky-vlan command to define the P330 stack's leaky VLAN mode. In
this mode, VLAN test is done only on broadcast/multicast/unknown frames, and
not on unicast frames.
Note: The leaky-vlan feature is not supported in P330-ML switches. This command
is used to set the leaky-vlan mode for other P330 switches in the stack.
The syntax for this command is:
set leaky-vlan <enable|disable>
Output Example:
P330-N# set leaky-vlan enable
Leaky VLAN mode enabled
set spantree
Use the set spantree command to enable/disable the spanning-tree protocol
for the stack.
Note: When you disable STP, blocking ports are disabled in order to prevent loops
in the network. As a result, you should wait 30 seconds before disabling STP if you
reset the switch, enabled STP, or inserted a new station.
The syntax for this command is:
set spantree {enable|disable}
Output Example:
P330-N# set spantree enable
bridge spanning tree enabled.
Avaya P333T-PWR User's Guide
Chapter 5 CLI – Layer 2
111