Configuring A Vlan Using Acli - Avaya 5900 Series Quick Start Configuration

Ethernet routing switch

Hide thumbs Also See for 5900 Series:

Installing manual (77 pages)

Installing (64 pages)

Installation job aid (13 pages)

Table Of Contents

Table of Contents

Procedure

1. Enter Privileged EXEC mode:

enable

2. At the command prompt, enter the following command:

quickconfig start-recording

3. Record your required Quick Configuration by entering one command on each line in ACLI.

See the following example.

Important:

The first two commands must be enable and config term, otherwise the

configuration commands that follow do not apply.

Use $ as a wildcard for the slot. The unit number is not known when a new unit joins a

stack, so the wildcard can match any slot number.

To end the recording process enter a . on the last line in ACLI.

Example

The following example records a Quick Configuration for VLAN and port configurations that applies

to a new unit joining a stack if Quick Configuration is enabled:

enable

config term

vlan port $/13-40 tag untagPvidonly

vlan create 10 name vlan_10 type port

vlan create 20 name vlan_20 type port

vlan members add 10 $/13-40

vlan members add 20 $/13-40

interface fast $/13-34

speed 100

end