Chapter 6
CLI – Layer 2
show intelligent-multicast hardware-support
Use the show intelligent-multicast hardware-support command to
display the intelligent multicast hardware support configuration.
The syntax for this command is:
show intelligent-multicast hardware-support
Output Example:
P330-N> show intelligent-multicast hardware support
Intelligent-multicast HW configuration:
#
Module
-------
1 Support IPMc
show security mode
Use the show security mode command to display the status of the MAC
security feature at the stack level.
Note: This command does not affect the P330-ML modules. It applies only to the
other P330 modules in the stack.
The syntax for this command is:
show security mode
Output Example:
P330-1(super)# show security mode
Switch-level security mode disabled
show arp-tx-interval
Use the show arp-tx-interval command to display the keep-alive frames
transmission interval.
The syntax for this command is:
show arp-tx-interval
Output Example:
P330-N> show arp-tx-interval
ARP tx interval is set to 5 seconds.
88
Sub-Module
----------
Not Installed
Cascade
--------
Support IPMc
Avaya P334T-ML User's Guide