Show Cam Commands; Show Cascading Fault-Monitoring Command - Avaya P333R-LB User Manual

Show cam Commands

Use the show cam commands to display the CAM table entries for a specific port
or MAC Address.
Note: MACs associated with LAGs appear under the LAG ID, not under the LAG
port.
The syntax for this command is:
show cam [<mod_num>[/<port_num>]]
and
show cam mac <mac_addr>
Example:
P330-N> show cam 1/1
Dest MAC/Route Dest Destination Ports
------------------- -----------------
00-40-0d-59-03-78
00-d0-79-0a-0a-da
00-40-0d-43-1e-e9
etc...
P330-N> show cam mac 00-40-0d-88-06-c8
Dest MAC/Route Dest Destination Ports
------------------- -----------------
00-40-0d-88-06-c8
Total Matching CAM Entries Displayed = 1

Show cascading fault-monitoring Command

Use the show cascading fault-monitoring command to display the status of
the fault trap sending mode for cascading links.
The syntax for this command is:
show cascading fault-monitoring [<mod_num>]
Example:
P330-N> show cascading fault-monitoring 1
Module 1 cascading-down fault monitoring enabled.
Module 1 cascading-up fault monitoring enabled.
Avaya P333R-LB User's Guide
Chapter 5
1/1
1/1
1/1
1/1
Cajun Campus CLI – Layer 2
67