Maintaining Sata Solid State Drive In An Acx6160; Removing A Sata Solid State Drive From An Acx6160 - Juniper ACX6160 Hardware Manual

After cleaning the transceiver, make sure that the connector tip of the fiber-optic cable is clean. Use
only an approved alcohol-free fiber-optic cable cleaning kit such as the Cletop-S® Fiber Cleaner.
Follow the directions in the cleaning kit you use.
SEE ALSO
Maintaining ACX6160 Transceivers and Fiber-Optic Cables | 74

Maintaining SATA Solid State Drive in an ACX6160

IN THIS SECTION

Removing a SATA Solid State Drive from an ACX6160 | 84

Installing a SATA Solid State Drive in an ACX6160 | 85
Removing a SATA Solid State Drive from an ACX6160
The ACX6160 supports two 50 -GB Serial Advanced Technology Attachment (SATA) solid state drives
(SSD) as secondary boot drives or for log storage. The SATA SSD is a hot-insertable and hot-removable
field-replaceable unit (FRU). The SSDs are preinstalled in the ACX6160.
Before you remove an SATA SSD from the device, ensure that you understand how to prevent
electrostatic discharge (ESD) damage. See
Ensure that you have the following parts and tools available to remove a SATA SSD from an ACX6160:
• ESD grounding strap
• Phillips (+) screwdriver, number 1
• An electrostatic bag or antistatic mat
To remove a SATA SSD in an ACX6160:
1. Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the SATA SSD.
"Prevention of Electrostatic Discharge Damage" on page
84
128.