Connect Power to the PTX5000 High Capacity Wye AC PDUs
To connect an AC power cord to a High Capacity Wye AC PDU (see
Figure 45: High Capacity Wye AC PDU
1
Top Installation handle
—
2
Front installation handle
—
3
PDU OK LED
—
4
Power switch labeled (|) for the on position and ( )
—
for the standby position.
5
Air exhaust ventilation
—
To connect an AC power cord to a High Capacity Wye AC PDU (see
1. Switch off the customer-site circuit breakers. Ensure that the voltage across the AC power source is 0
V and that there is no chance that the voltage might become active during installation.
2. Move the circuit breaker on the faceplate of the PDU to the off position.
3. Move the power switch located on the faceplate of the PDU to the standby ( ) position.
Figure 45 on page
6
Circuit breaker
—
7
Input voltage LED
—
8
Wiring compartment
—
9
Metal retaining bracket
—
10
Wiring compartment door
—
Figure 45 on page
52):
52):
52