Converting The Customer Database - Nortel Meridian 1 Manual

Performing a data dump
Before converting your customer database, you must perform a data dump to
your current tapes or disks.
1 On the A, M, S, or MS system, log into the system.
2 Load the Equipment Data Dump Program (LD 43). At the prompt, enter
LD 43
Always enter LD 43 from the source (current) media.
3 When "EDD000" appears on the terminal, enter
EDD
4 When "DATABASE BACKUP COMPLETE" or "DATADUMP
COMPLETE" appears on the terminal, enter
****
If the data dump is not successful, do not continue; contact your
technical support organization. A data dump problem must be
corrected before proceeding.

Converting the customer database

If you choose to have the customer database converted, you must send it to
Northern Telecom for conversion; contact your Northern Telecom
representative to arrange for this. After you have received your converted
database, proceed to "Installing the connector housings" on page 2-10.
Alternatively, you can reenter the database on the option 51C after the
upgrade is complete. Refer to the section "Turning on the power and
configuring the system" on page 2-18 for data reentry procedures after the
upgrade is complete.
Upgrade system installation Upgrading to Meridian 1 system options
SL-1 A, M, S, and MS system upgrades
to load the program
to begin the data dump
to exit the program
CAUTION
2-9