Nortel Meridian 1 Manual page 879

Installing the connector housing
In this step, you will choose a mounting location for the connector housing on
the QCA108 and QCA55 cabinets, install the connector housing and bracket,
and route cables from within the cabinets to the connector housing.
There are several possible mounting locations (see Figure 12-24) for the
housings. The housing may be mounted at one of nine locations on the top of
the cabinet:
— horizontally, with the bracket mounted on either the top or front of the
housing
— vertically (on its end), with the bracket mounted on one side of the
housing
The housing may also be mounted at one of four locations on either side of
the cabinet:
— parallel to the floor, with the bracket mounted on one of the sides of the
housing
— perpendicular to the floor, with the bracket mounted on one of the sides
of the housing
Note: When choosing a location for the connector housing on the
QCA55 cabinet, select a location close to the junctor panel so that the
4–foot clock to I/O cable will reach from the junctor panel to the
connector housing.
Upgrade system installation Upgrading to Meridian 1 system options
Upgrades to Meridian 1 option 81 12-115