Nortel Meridian 1 Manual page 729

10-56 Meridian 1 option 61 upgrades
553-3001-250 Standard 14.00 August 1996
7 When the install screen appears, select the following options in
sequence, and insert the B diskette containing the customer database
(that you converted during the upgrade preparation procedures) when
you are prompted to do so:
<d>
<c>
<a>
<a>
<b>
<y>
<a>
Follow all screen directions until the database transfer is complete.
8 Select the following options to quit and reload the system:
<q>
<yes>
9 Remove any diskettes from the floppy drive and type
<a>
10 Watch the terminal for system reload (SYS) and initialization (INI)
messages. Following this, Core 0 is operational. If the sysload or
initialization fails, refer to "Troubleshooting" on page C-1.
Completing the Core 0 upgrade
1 Configure networks as CNI groups, based on the number of CNI cards in
the system. In an option 61C configuration, there is only one CNI card
and one network group. See X11 input/output guide (553-3001-400) for
a complete description of the Configuration Record (LD 17).
2 Evaluate the number of call registers and 500 telephone buffers that are
configured for the system (suggested minimum values are 1000 and 500,
respectively). Refer to Meridian 1 capacity engineering (553-3001-149).
If changes are required, reconfigure the values in LD 17.
to install the database
to transfer the pre-option 61C database
to transfer the database to hard disk
to convert from an HD floppy disk
or
to convert from an ED floppy disk
to begin the installation
to confirm the database conversion
to quit
to confirm quit
to reboot the system