Nortel Meridian 1 Manual page 120

Insert the additional system disk (A2) when requested. When the restore
sequence is complete, enter
****
41 Remove disk A2 from drive A and insert disk A1.
42 Set the ENB/DIS switch on the EMSI card to DIS.
43 Remove the EMSI card and set position 4 on switch SW3 to ON.
44 Reinstall the EMSI card and set the ENB/DIS switch to ENB.
Note: Normal SDI ports are assumed to be on an SDI2 card type. The
card type will have to be updated manually for other SDI card types. This
can only be done by using the ADAN prompt in LD 17 with the OUT and
NEW commands as outlined in the following step.
45 Define the I/O port card type for each SDI port on the MSPS card:
LD 17
ADAN
ADAN data outed
ADAN
CTYP
USER
ADAN data saved
****
Enable each port:
LD 37
ENL terminal x
****
Note: SDI ports are configured as a pair (for example, 0 and 1 or 2
and 3). Make sure there is no conflict with an existing port.
Upgrade system installation Upgrading to Meridian 1 system options
SL-1 ST and STE system upgrades
to exit the program
to load the program
enter OUT terminal x to remove an I/O
device
is displayed
enter NEW terminal x to specify a new I/O
device
enter MSPS to specify card type
enter appropriate terminal functions
is displayed
to exit the program
to load the program
to enable port x
to exit the program
4-41