Nortel Meridian 1 Manual page 104

52 Immediately following the system initialization sequence, remove the
disk from drive A and insert disk A1.
53 Log into the system.
54 Update the Configuration Record:
LD 17
ADAN
FTYP
****
55 Copy the contents of the data disks to the hard disk by entering
LD 43
RES
Insert additional system disks (A2, A3, etc.) in the A drive when
prompted. When the restore sequence is complete, enter
****
56 remove the disk from drive A and insert disk A1.
57 Set the ENB/DIS switch on the EMSI card to DIS.
58 Remove the EMSI card and set position 4 on switch SW3 to ON.
59 Reinstall the EMSI card and set the ENB/DIS switch to ENB.
Note: Normal SDI ports are assumed to be on an SDI2 card type. The
card type will have to be updated manually for other SDI card types. This
can only be done by using the ADAN prompt in LD 17 with the OUT and
NEW commands as outlined in the following step.
Upgrade system installation Upgrading to Meridian 1 system options
SL-1 ST and STE system upgrades
to load the program
enter CHG HDK 0 to specify a single SMDU
enter 3S to specify 3.5-in. extra-high-density disks
to exit the program
to load the program
to copy the entire contents of the backup to the
hard disk
to exit the program
4-25