Nortel Meridian 1 Manual page 463

Upgrade system installation through x11 release 21

Hide thumbs Also See for Meridian 1:

Table of Contents

Meridian 1 option 21 upgrades

553-3001-250 Standard 14.00 August 1996

37 Slide the perforated panel slightly to the left, when you are looking at it

from the rear of the column. Lift the panel and turn it over.

38 Position the thermostats and install the screws (two each) that secure the

thermostats. Refer to Figure 8-10 for the thermostat harness.

Positioning the thermostat harness

Note: The column LED and LED wiring are part of the thermostat

39 Push the LED through the rubber grommet at the front of the perforated

40 Route the thermostat wiring on the perforated panel. At the rear edge of

the panel, route the wires with the wiring for the fan units.

41 Gently push the air probe into the clip holder on the perforated panel.

To connector J2

Chapters

Table of Contents