Nortel Meridian 1 Manual page 464

42 Route the air probe wiring on the perforated panel as illustrated in
Figure 8-11. At the rear edge of the panel, route the wires with wiring for
the thermostat harness.
Figure 8-11
Positioning the air probe harness
To orange connector
Air probe
43 Secure all loose cabling to the perforated panel with tie wraps provided
in the upgrade package.
44 Turn the perforated panel over. Slide it slightly to the right, when
viewing it from the rear of the column, so it is in a secure position.
45 Position wiring from the perforated panel so it rests in the cable well at
the top rear of the module as shown in Figure 8-12.
46 Insert the orange connector from the air probe harness into the
right-angle bracket next to the cable well. Simultaneously push the four
small snaps, two on each side, on the connector to insert the connector.
Figure 8-12
Routing the thermostat and air probe wiring from the top cap
Top of
module
Upgrade system installation Upgrading to Meridian 1 system options
Meridian 1 option 21 upgrades
Air probe
wiring
Front
Cable well Orange connector
View at rear of module
Perforated
panel
(bottom)
553-5887
Bracket
553-5889
8-21