Completing The Upgrade - Nortel Meridian 1 Manual

4 Select the following options to quit and reload the system:
<q>
<yes>
5 Remove any diskettes from the floppy drive and type
<a>
6 Watch the terminal for system reload (SYS) and initialization (INI)
messages. Following this, the option 51C core is operational. If the
sysload or initialization fails, refer to "Troubleshooting" on page C-1.

Completing the upgrade

1 Evaluate the number of call registers and 500 telephone buffers that are
configured for the system (suggested minimum values are 1000 and 500,
respectively). Refer to Meridian 1 capacity engineering (553-3001-149).
If changes are required, reconfigure the values in LD 17.
2 Load overlay 22 and print the Configuration Record to verify the above
changes:
LD 22
REQ PRT
TYPE CFN
After verifying the changes, enter
****
3 Load the Equipment Data Dump Program (LD 43). At the prompt, enter
LD 43
When "EDD000" appears on the terminal, perform the data dump. At the
prompt, enter
EDD
When "DATABASE BACKUP COMPLETE" or "DATADUMP
COMPLETE" appears on the terminal, proceed to the next step.
Upgrade system installation Upgrading to Meridian 1 system options
Meridian 1 option 51 upgrades
to quit
to confirm quit
to reboot the system
to load the program
to set the print option
to print the configuration
to exit the program
to load the program
to begin the data dump
9-49