Nortel Meridian 1 Manual page 117

4-38 SL-1 ST and STE system upgrades
553-3001-250 Standard 14.00 August 1996
23 Unpack the NTND01 ICM card from its carton. Verify that the NTND31
ROM card is installed on the ICM card. If it is not, install the NTND31
ROM card on the ICM card, and install the ICM card in slot 2.
Carefully align the connector pins when installing a ROM card.
Failure to use care may result in damage to one of the cards or system
failure.
24 Set the ENB/DIS switch on the NTND02 MSPS card to DIS.
25 Set option switches on the NTND02 MSPS card to activate SDI ports. To
avoid conflicting addresses, determine the appropriate option switch
settings. Refer to Circuit card installation and testing (553-3001-211).
26 Connect the battery pack on the NTND02 MSPS card by plugging the
battery clip connector to the clip connector on the card as illustrated in
Figure 4-4.
Note: The battery will not be fully charged until 24 hours after
installation in a powered system.
Figure 4-4
Battery pack connection to the NTND02 MSPS card
Battery pack
Mounting screws
27 Install the NTND02 MSPS card in slot 3.
CAUTION
Clip
connector
553-5566