Nortel Meridian 1 Manual page 460

25 Connect the narrow ribbon from an NT8D46AG cable from connector J2
on the backplane to the assigned port on the SDI Paddle Board.
26 Set the circuit breaker on the front of the Pedestal Blower Unit to OFF.
27 Set the NT8D52AB Pedestal Blower Unit on the bottom ledge of the
pedestal.
28 Tilt the back of the Pedestal Blower Unit up slightly so it will slide into
the pedestal glides. You may have to lift the unit and gently push the
Pedestal Blower Unit into position.
29 Tighten the screws on the front of the Pedestal Blower Unit.
Figure 8-6
Pedestal Blower Unit and the air filter in the front of the pedestal
Air filter
Upgrade system installation Upgrading to Meridian 1 system options
Meridian 1 option 21 upgrades
Blower unit
8-17
553-3002