Nortel Meridian 1 Manual page 953

Figure 12-42
P0702380 Connector Housing
Secure housing to cabinet
4 Using the hardware provided with the housing, secure the NT9J96 cables
to the inside of the P0696547 Connector Housing.
5 Route the NT9J96 cables through the cabinet opening to the inside of the
cabinet.
Note: Leave the cables disconnected inside the cabinet. They will be
connected later in the upgrade.
6 Mount the housing(s) and secure it to the side panel with four #6 sheet
metal screws.
7 Connect the NT8D73 cables from the Network Modules to the outside of
the P0696547 Connector Housing.
Mounting the P0702380 Connector Housing
Refer to Figure 12-42 and Figure 12-43 while performing these steps:
1 On the top of the PE cabinet, remove the cover from the selected opening
on the I/O panel. Keep the four screws for reuse.
with existing nuts
Upgrade system installation Upgrading to Meridian 1 system options
Upgrades to Meridian 1 option 81
P0702380 Connector Housing
12-189
Cable access
opening in cabinet
I/O panel
553-3182