Chery T21 2014 Service Manual page 951

Primary Shaft Pressure Sensor
Removal
1. Turn off all the electrical devices and ignition switch.
2. Disconnect the negative battery cable.
3. Raise the vehicle with a lifter.
4. Drain the automatic transmission fluid
5. Disconnect the wire harness connector of the primary
shaft pressure sensor.
6. Remove the primary shaft pressure sensor (1). 
(Tightening torque: 15 - 22 N·m)
Installation
Installation is in the reverse order of removal.
CAUTION
 Keep clean of sensor and contact surface between sensor and transmission, and avoid dust or impurity
entering the transmission.
 During installation, apply automatic transmission fluid on the O ring of the sensor.
 Add automatic transmission fluid
Chery Automobile Co., Ltd.
(See page 18-110).
(See page 18-110).
18 - QR019CHB CVT
RT21180400
1
RT21180410
18
117
18–