Chery T21 2014 Service Manual page 1160

25 - BRAKE CONTROL SYSTEM
e. Look for broken, bent, protruded or corroded terminals.
f. Check if related connector pins are in good condition.
Repair or replace ABS control module
NG
assembly wire harness and connector
4
Check wire harness and connector (ABS control module assembly - battery)
a. Turn ignition switch to LOCK.
b. Disconnect the negative battery cable.
c. Disconnect the ABS control module assembly connector
E-085.
d. Connect the negative battery cable.
e. Turn ignition switch ON.
f. Using a digital multimeter, measure the supply voltage
between ABS control module assembly connector E-085
and body ground to check if the power supply circuit is
normal according to the table below.
Standard Voltage
Multimeter
Connection
Terminal
E-085 (28) - Body
ground
Repair or replace engine compartment
NG
wire harness and connector
25
64
25–
Specified
Condition
Condition
Ignition switch ON 9 to 16 V
V
+ -
12 11 10 9 8 7 6 5 4 3 2
13
24 23 22 21 20 19 18 17 16 15 14
38
37 36 35 34 33 32 31 30 29 28 27 26
E-085
Chery Automobile Co., Ltd.
OK
1
25
RT21250470
OK