Chery T21 2014 Service Manual page 1167

ABS Control Module Assembly
Removal
WARNING
 When repairing ABS system, first release the pressure of high pressure brake fluid in the accumulator, to
prevent the high pressure brake fluid from spraying out and causing injury.
 Operation procedures: turn ignition switch off first, and then depress and release brake pedal repeatedly
until brake pedal becomes hard.
 In addition, never turn the ignition switch on before the ABS system is installed completely to prevent the
hydraulic pump from energizing and running.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Drain the brake fluid (See page
CAUTION
 Wash off brake fluid immediately if it comes in contact with any paint surface.
ENVIRONMENTAL PROTECTION
 Drained brake fluid should be well kept in a container. Never discard it at will.
4. Remove the engine trim cover assembly.
5. Remove the ABS control module assembly.
a. Press the lock area of ABS control module assembly
connector, move the connector lock bracket upward
and disconnect the ABS control module assembly
connector (arrow).
b. Using a fixing wrench, carefully disconnect 6 brake
pipe coupling plugs (arrow).
(Tightening torque: 16 ± 2 N·m)
Chery Automobile Co., Ltd.
26-13).
25 - BRAKE CONTROL SYSTEM
RT21250070
RT21250080
25–
25
71