Chery T21 2014 Service Manual page 754

15 - SQR484F STARTING SYSTEM
Inspection
1. Check for continuity of engine switch.
Using ohm band of the digital multimeter, check for
continuity of engine switch according to the table below.
Multimeter
Connection
Terminal 1 -
Terminal 2
Terminal 3 -
Terminal 2
Terminal 1 -
Terminal 2
Terminal 3 -
Terminal 2
If result is not as specified, replace the engine switch.
2. Check engine switch indicator illumination.
Apply battery voltage between terminals of engine
switch, check engine switch indicator illumination.
HINT:
 If positive (+) lead and negative (-) lead are connected
incorrectly, the engine switch indicator does not come
on.
 When battery voltage is too low, the engine switch
indicator does not come on.
Measurement
Condition
15
Battery positive
(+) → Terminal 4
Battery negative
(-) → Terminal 2
Battery positive
(+) → Terminal 5
Battery negative
(-) → Terminal 2
Battery positive
(+) → Terminal 8
Battery negative
(-) → Terminal 2
If result is not as specified, replace the engine switch
Installation
Installation is in the reverse order of removal.
70
15–
Switch Specified
Condition Condition
Not pushed No continuity
Not pushed No continuity
Pushed Continuity
Pushed Continuity
Specified
Condition
Condition
Come on
Always
(stamping word)
Always Come on (amber)
Always Come on (green)
+ -
-
+
Chery Automobile Co., Ltd.
5 6 7 8
1 2 3 4
RT21150190
5 6 7 8
1 2 3 4
RT21150200