Chery T21 2014 Service Manual page 1293

Steering Tie Rod Assembly
Removal
HINT:
 Use the same procedures for the right side and left side.
 Procedures listed below are for the left side.
1. Remove the battery (See page
2. Remove the battery tray
3. Remove the front wheel
4. Remove the ball pin assembly
5. Remove the steering tie rod assembly.
a. Remove the steering tie rod boot clamp (2).
b. Remove the steering tie rod boot clamping ring (1)
and remove the steering tie rod boot.
CAUTION
 Operate carefully to prevent damaging the boot.
 It is necessary to replace with new clamping ring when reinstalling steering tie rod boot.
c. Using a wrench, remove the steering tie rod ball pin
(arrow).
Inspection
1. Check steering tie rod boot for damage, and clamp for normality. Replace the steering tie rod boot and
clamp if necessary to prevent water and micro dust from entering and causing parts failure prematurely.
2. Check steering tie rod assembly for deformation or wear, and ball for insufficient lubrication. Replace
steering tie rod assembly or add grease if necessary.
Chery Automobile Co., Ltd.
16-7).
(See page 16-7).
(See page 24-9).
(See page 29-19).
29 - HYDRAULIC ASSIST STEERING
1
2
RT21290170
RT21290171
29–
29
21