Chery T21 2014 Service Manual page 1073

Rear Stabilizer Bar Assembly
Removal
CAUTION
 Be sure to wear necessary safety equipment to prevent accidents.
 Make sure that safety lock of lifter has been locked when removing and installing chassis parts.
 It is not permitted to weld or modify suspension bearing parts.
 When removing and installing chassis parts, replace self-locking nuts and rusted nuts for safety.
1. Remove the rear stabilizer bar assembly.
a. Remove the coupling nut (arrow) between upper part
of rear left stabilizer link assembly and rear stabilizer
bar assembly. Use the same removal procedure for
the right side.
(Tightening torque: 45 ± 5 N·m)
b. Remove the fixing clamp (arrow) from rear left brake
line and disconnect the brake pipe fixing plug (1). Use
the same removal procedure for the right side.
(Tightening torque: 16 ± 2 N·m)
CAUTION
 DO NOT bend or damage brake tube.
 DO NOT allow any foreign matter such as dirt and dust to enter brake tube from the connecting parts.
 After removing brake line, take seal measures to prevent foreign matter from entering.
Chery Automobile Co., Ltd.
23 - SUSPENSION
RT21230480
1
RT21230490
23
43
23–