32 - SUPPLEMENTAL RESTRAINT SYSTEM
DIAGNOSIS & TESTING
SRS Control Module Assembly Terminal List
Terminal No.
1
Power Supply
2
CAN-L1
3
Driver Airbag Positive
4
Driver Airbag Negative
5
Front Passenger Airbag Negative
32
6
Front Passenger Airbag Positive
Front Passenger Seat Belt
7
Pretensioner Positive
Front Passenger Seat Belt
8
Pretensioner Negative
Driver Seat Belt Pretensioner
9
Negative
Driver Seat Belt Pretensioner
10
Positive
11
-
12
-
13
-
14
-
15
-
16
Ground
DTC Confirmation Procedure
Confirm that battery voltage is over 12 V before performing the following procedures.
Turn ignition switch to LOCK.
Connect X-431 3G diagnostic tester (the latest software) to Data Link Connector (DLC).
Turn ignition switch ON.
Use X-431 3G diagnostic tester to record and clear the DTCs stored in the supplemental restraint system.
Turn ignition switch to LOCK and wait for a few seconds.
Turn ignition switch ON, and then select "Read Code".
If DTC is detected, the malfunction indicated by the DTC is current. Go to the diagnosis procedure - Step 1.
If DTC is not detected, the malfunction indicated by the DTC is intermittent. Please refer to Intermittent
DTC Troubleshooting.
Intermittent DTC Troubleshooting
If malfunction is intermittent, perform the followings:
Check if connectors are loose.
Check if wire harnesses are worn, pierced, pinched or partially broken.
Monitor X-431 3G diagnostic tester (the latest software) data that is related to this circuit.
10
32–
Terminal Definition
Terminal No.
Terminal Definition
17
CAN-H1
18
-
19
-
20
Front Passenger Seat Belt Switch
21
-
22
-
23
-
24
-
25
Seat Belt Reminder
26
-
27
-
28
-
29
-
30
-
31
-
32
-
Chery Automobile Co., Ltd.