Chery T21 2014 Service Manual page 1235

Parking Brake Switch Assembly
On-vehicle Inspection
1. Disconnect parking brake switch assembly connector,
and check the continuity of parking brake switch
assembly with ohm band of digital multimeter as shown
in the table below.
Standard Condition
Multimeter
Condition
Connection
Parking brake
applied (switch
pin released)
Terminal 1 - Body
ground
Parking brake
released (switch
pin pushed)
If result is not as specified, replace parking brake switch
assembly.
Removal
CAUTION
 Be sure to wear necessary safety equipment to prevent accidents when repairing.
 Try to prevent body paint surface from being scratched during removal and installation.
1. Fix the tire and wheel assembly.
2. Remove the auxiliary fascia console assembly
3. Remove the parking brake switch assembly.
a. Disconnect the parking brake switch assembly wire
harness connector (arrow) as shown in the illustration.
Chery Automobile Co., Ltd.
+ -
Specified
Condition
Continuity
No continuity
(See page 45-9).
27 - PARKING BRAKE
1
RT21270040
RT21270050
27
9
27–