Chery T21 2014 Service Manual page 1119

Self-diagnosis Detection Logic
DTC Code DTC Definitions
C0010-04 Left Front Inlet Control
Left Front Outlet
C0011-04
Control
Right Front Inlet
C0014-04
Control
Right Front Outlet
C0015-04
Control
C0018-04 Left Rear Inlet Control
Left Rear Outlet
C0019-04
Control
Right Rear Inlet
C001C-04
Control
Right Rear Outlet
C001D-04
Control
C1003-04 Valve Relay
C1004-00 General Valve
CAUTION
 When performing electrical equipment diagnosis and test, always refer to the circuit diagram for related
circuit and component information.
Diagnosis Procedure
1
Check for DTCs
a. Leave the vehicle for 5 minutes, clear and read the ABS control module assembly DTC again with X-431
3G diagnostic tester.
b. Refer to DTC Confirmation Procedure.
c. Check if the same DTC is output.
Problem indicated by DTC is intermittent
NO
(system overheat protection)
Chery Automobile Co., Ltd.
DTC Detection
Conditions
These DTCs occur
when any of the
following conditions is
met:
1. Valve power supply
malfunction (power
supply is short to
ground or ground is
 Valve relay power supply is abnormal.
open).
 ABS control module assembly has
2. Solenoid valve
temperature is too
 Fuse is malfunctioning.
high (overheat
 Solenoid valve is short to power
protection).
3. Short in solenoid
 System overheat protection.
valves more than 5
(fuse).
 ABS control module assembly is
4. Activate the
corresponsive
solenoid valve, but
no feedback.
5. Solenoid valve itself
is malfunctioning.
6. Valve set relay is
malfunctioning.
25 - BRAKE CONTROL SYSTEM
Possible Cause
poor ground connection.
supply and ground, or ground is open.
damaged.
25
YES
23
25–