Chery T21 2014 Service Manual page 1187

5. Repeat above steps, and bleed the brake lines of each wheel in the same manner in the order of rear left
wheel, front right wheel, rear right wheel and front left wheel, until all air are bled from the brake lines.
Empty sign: a stream of fresh brake fluid flows into the clear container without bubbles.
HINT:
During bleeding the brake system, make sure the brake
fluid level is always near the "MAX" mark. Check the
brake fluid level at all times during bleeding. Add brake
fluid as necessary.
6. Check and adjust the brake fluid level to the "MAX" mark.
7. Check brake pedal effect. If braking effect is improper or the pedal is spongy, air may still exist in the
system. Perform bleeding procedures again for brake system as necessary.
8. Have the vehicle tested to confirm that brake operates properly and pedal feel is correct.
Brake Fluid Replacement
1. Drain the brake fluid.
a. Start the engine and run it at idle.
b. Remove the filler cap of brake fluid reservoir assembly. Remove the bleeder plug cap and connect a
clear plastic hose to the bleeder plug, and submerge the end of hose into the clear container filled with
new brake fluid.
c. Loosen the bleeder plug, and depress the brake pedal
continuously until the brake fluid stops coming out.
2. Add brake fluid.
a. Tighten the bleeder plug after confirming that brake fluid is drained. Fill the brake fluid reservoir with
new brake fluid to the proper level.
3. Perform bleeding procedures.
a. After replacing with new brake fluid, make sure to bleed the brake system for normal operation.
page 26-12 for detail information about brake bleeding.
Chery Automobile Co., Ltd.
26 - BRAKE
RT21260050
RT21260030
See
26
13
26–