Chery T21 2014 Service Manual page 1057

Front Stabilizer Link Assembly
Removal
CAUTION
 Be sure to wear necessary safety equipment to prevent accidents.
 Make sure that safety lock of lifter has been locked when removing and installing chassis parts.
 It is not permitted to weld or modify suspension bearing parts.
 When removing and installing chassis parts, replace self-locking nuts and rusted nuts for safety.
HINT:
 Use the same procedures for the right side and left side.
 Procedures listed below are for the left side.
1. Remove the front left wheel
2. Remove the front left stabilizer link assembly.
a. Hold the lower end of front left stabilizer link assembly
with an inner hexagon wrench, and remove the
coupling nut (arrow) between front left stabilizer bar
assembly and front left stabilizer link assembly with a
fixing wrench.
(Tightening torque: 45 ± 5 N·m)
b. Hold the upper end of front left stabilizer link assembly
with an inner hexagon wrench, and remove the
coupling nut (arrow) between front left stabilizer link
assembly and front left shock absorber assembly with
a fixing wrench.
(Tightening torque: 45 ± 5 N·m)
c. Remove the front left stabilizer link assembly.
Inspection
1. Check front stabilizer link assembly.
a. Check front stabilizer link assembly bushes for wear, cracks, deformation, damage or grease leakage.
Replace as necessary.
b. Check if the end of front stabilizer link assembly rotates smoothly. Replace as necessary.
Chery Automobile Co., Ltd.
(See page 24-9).
23 - SUSPENSION
SUSPENSION
RT21230240
RT21230031
23
27
23–