Chery T21 2014 Service Manual page 1075

Rear Stabilizer Link Assembly
Removal
CAUTION
 Be sure to wear necessary safety equipment to prevent accidents.
 Make sure that safety lock of lifter has been locked when removing and installing chassis parts.
 It is not permitted to weld or modify suspension bearing parts.
 When removing and installing chassis parts, replace self-locking nuts and rusted nuts for safety.
HINT:
 Use the same procedures for the right side and left side.
 Procedures listed below are for the left side.
1. Remove the rear left wheel
2. Remove the rear left stabilizer link assembly.
a. Remove the coupling nut (arrow) between lower part
of rear left stabilizer link assembly and rear
suspension lower left swing arm assembly.
(Tightening torque: 45 ± 5 N·m)
b. Remove the coupling nut (arrow) between upper part
of rear left stabilizer link assembly and rear stabilizer
bar assembly.
(Tightening torque: 45 ± 5 N·m)
c. Remove the rear left stabilizer link assembly.
Inspection
1. Check rear stabilizer link assembly.
a. Check rear stabilizer link assembly bushes for wear, cracks, deformation, damage or grease leakage.
Replace as necessary.
b. Check if the end of rear stabilizer link assembly rotates smoothly. Replace as necessary.
Chery Automobile Co., Ltd.
(See page 24-9).
23 - SUSPENSION
RT21230370
RT21230480
23
45
23–