Chery T21 2014 Service Manual page 1291

Ball Pin Assembly
Removal
HINT:
 Use the same procedures for the right side and left side.
 Procedures listed below are for the left side.
1. Remove the front wheel
2. Remove the ball pin assembly.
a. Remove the locking nut (arrow) between left steering
tie rod assembly ball pin and front left steering knuckle
assembly.
(Tightening torque: 35 ± 3 N·m)
b. Install the ball pin separator (1), and tighten the ball
pin separator bolt with a wrench (2) to separate the
steering tie rod ball pin and steering knuckle assembly
c. Loosen the steering tie rod adjustment nut (1), and
turn the ball pin assembly (2) counterclockwise to
remove it.
(Tightening torque: 55 ± 5.5 N·m)
HINT:
When removing the ball pin assembly, record the revolutions during removal to make the front wheel toe-in
closer to the setting value after installation.
Inspection
Check ball pin assembly for looseness and insufficient lubrication and bush rubber for damage. Replace the
ball pin assembly if necessary.
Chery Automobile Co., Ltd.
(See page 24-9).
29 - HYDRAULIC ASSIST STEERING
RT21220120
2
1
RT21220130
1
2
RT21290160
29–
29
19