Chery T21 2014 Service Manual page 537

CAUTION
 Operate carefully when pulling the electric fuel pump assembly out of fuel tank, preventing damaging
lines, wire harnesses and fuel level sensor.
 To keep fuel tank portion clean, cover it completely with a plastic bag or equivalent to prevent foreign
matter from entering.
 The electric fuel pump assembly can be put into a container and taken out of the cabin, thus preventing
fuel in the pump from dropping into the cabin.
g. Take the electric fuel pump assembly out of fuel tank.
7. Drain the fuel in the electric fuel pump assembly.
CAUTION
 Cover electric fuel pump assembly completely with a plastic bag or equivalent to prevent foreign matter
from entering.
 It is not allowed to perform running test for electric fuel pump assembly under dry or water condition.
Otherwise it will reduce its service life. In addition, DO NOT connect battery positive and negative poles
inversely.
Installation
Installation is in the reverse order of removal.
CAUTION
 DO NOT connect the negative battery cable during installation. Work area should be in good ventilation
and keep fire sources or open flames away.
 To avoid damaging electric fuel pump assembly, align electric fuel pump assembly with installation
position of fuel tank and DO NOT run the electric fuel pump assembly without fuel in fuel tank.
 Before connecting hose, check if there is any damage or foreign matter on hose or joint.
 During installation, push in fuel pipe connector until a click sound is heard, then check that fuel pipe joint
clip is on the collar of fuel pipe joint. After installing the pipe joint clip, check that fuel pipe joint cannot be
pulled out. Be careful not to damage the joint. If the clip is damaged, replace it.
 Turn ignition switch ON (without starting engine) to apply fuel pressure to fuel supply system, and then
check connections for leakage.
Chery Automobile Co., Ltd.
08 - SQR484F FUEL SUPPLY SYSTEM
08
17
08–