Chery T21 2014 Service Manual page 1157

n. Using a digital multimeter, check for continuity between
the terminal 1 of connector B-009 and the terminal 2 of
connector B-054 to check if there is an open in the rear
right wheel speed sensor signal wire according to the
table below.
Standard Condition
Multimeter
Connection Condition
Terminal
B-009 (1) - B-054
(2)
Repair or replace wire harness and
NG
connector between wheel speed sensor
and ABS control module assembly
6
Reconfirm DTCs
a. Use X-431 3G diagnostic tester to clear the DTC.
b. Start the engine.
c. Drive the vehicle at 15 km/h or more, read the ABS control module assembly DTC again with X-431 3G
diagnostic tester.
d. Check if the same DTC is output.
System operates normally
NO
Replace ABS control module assembly
Chery Automobile Co., Ltd.
Specified
Condition
Always Continuity
25 - BRAKE CONTROL SYSTEM
+ -
2 1
B-009
1 2 3 4 5 6 7 8
12 13 14 15 16 17 18 19 20 21 22
B-054
9 10 11
RT21250460
OK
YES
25
61
25–