25 - BRAKE CONTROL SYSTEM
2
Check ABS fuse
a. Turn ignition switch to LOCK.
b. Disconnect the negative battery cable.
c. Remove the ABS fuse MF-01 (40 A) from the engine compartment fuse and relay box.
d. Check if the fuse is blown.
Replace ABS fuse
NG
3
Check wire harness and connector
Use the circuit diagram as a guide to perform the following procedures:
Turn ignition switch to LOCK.
Disconnect the negative battery cable.
Disconnect the ABS control module assembly connector E-085.
Check if the wire harnesses are worn, pierced, pinched or partially broken.
Look for broken, bent, protruded or corroded terminals.
Check if related connector pins are in good condition.
Repair or replace engine compartment
NG
wire harness and connector
4
Check wire harness and connector (ABS control module assembly - battery)
a. Connect the negative battery cable.
b. Turn ignition switch to LOCK.
c. Disconnect the ABS control module assembly connector
E-085.
d. Using a digital multimeter, measure the voltage between
ABS control module assembly terminal 1 and body
ground to check if the power supply circuit is normal
according to the table below.
Standard Voltage
Multimeter
Connection
25
E-085 (1) - Body
ground
Repair or replace engine compartment
NG
wire harness and connector
28
25–
Specified
Condition
Condition
Always
9 to 16 V
V
+
-
12 11 10 9 8 7 6 5 4 3 2
13
24 23 22 21 20 19 18 17 16 15 14
38
37 36 35 34 33 32 31 30 29 28 27 26
E-085
Chery Automobile Co., Ltd.
YES
OK
OK
1
25
RT21250220