Chery T21 2014 Service Manual page 1188

26 - BRAKE
Brake Fluid Reservoir Assembly
On-vehicle Inspection
1. Check the brake fluid level warning switch.
a. Remove the brake fluid reservoir filler cap.
b. Disconnect the brake fluid level warning switch wire
harness connector.
c. Using ohm band of digital multimeter, check for
continuity between brake fluid level warning switch
terminals according to conditions shown in the table
below.
Standard Condition
Multimeter
Connection
Terminal 1 -
Terminal 2
Terminal 1 -
Terminal 2
HINT:
 There is a float in the fluid reservoir. The position of float changes according to increasing or decreasing
brake fluid level.
 If result is not as specified, replace brake fluid reservoir assembly.
d. Add brake fluid to the "MAX" mark.
Removal
1. Drain the brake fluid
ENVIRONMENTAL PROTECTION
 Drained brake fluid should be well kept in a container. Never discard it at will.
CAUTION
 Wash off brake fluid immediately if it comes in contact with any paint surface.
2. Remove the brake fluid reservoir assembly.
a. Disconnect the brake fluid level warning switch
connector (arrow).
26
14
26–
Specified
Condition
Condition
Float upward
No continuity
(switch ON)
Float downward
Continuity
(switch OFF)
(See page 26-13).
+ -
1 2
Chery Automobile Co., Ltd.
RT21260060
RT21260070