Chery T21 2014 Service Manual page 1172

25 - BRAKE CONTROL SYSTEM
Rear Wheel Speed Sensor
Removal
CAUTION
 Keep the wheel speed sensor away from oil or other dirt. Otherwise, the speed signal generated by
wheel speed sensor may be inaccurate, and the system may fail to operate normally.
HINT:
 Use the same procedures for the right side and left side.
 Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear left wheel
4. Remove the left C-pillar lower protector assembly
5. Remove the rear left wheel speed sensor.
a. Remove the coupling bolt (arrow) between rear left
wheel speed sensor and rear left hub bearing unit,
and disengage the rear left wheel speed sensor.
(Tightening torque: 10 ± 1 N·m)
CAUTION
 Keep the head and installation hole of sensor free of foreign matter.
b. Loosen the fixing bands (arrow) from the rear left
wheel speed sensor wire harness.
25
76
25–
(See page 24-9).
(See page 49-23).
Chery Automobile Co., Ltd.
RT21250143
RT21250150